ДГ411ДИЗ

Обзор DG411DYZ

As the electronic part is packed in SOIC, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. A 15V voltage supply should turn on and run the electronic component. Internally, this switch multiplexer has a resistance of 80Ohm. To find out what the 16 pins do, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 40V. A analog switch ic that has a cost-effective Dual, Single supply type. The lowest voltage fed to the electronic component should be 5V. 100pA current would be enough for this multiplexer to operate. For this switch, a dual supply voltage is feasible, but it must not exceed 20VIf you are using a dual power supply, you should attach at least 5V. There are SEPARATE OUTPUT outputs on this analog switch ic. Operating voltages range from 28V. Temperatures above 85°C should not be used to operate the switches. There is 25mOhm resistance between Drain and Source for this electronic part. The switch device is capable of conducting in a 4-bit mode.

Особенности DG411DYZ

1 Channels
100pA Supply Current
Drain-to-Source resistance: 25mOhm
4-Bit

Приложения DG411DYZ

There are a lot of Intersil (Renesas Electronics America) DG411DYZ Analog Switches & Multiplexers ICs applications.

• Канальные и неканальные приложения DS3
• КПК
• Оптические приложения
• Многоканальные интерфейсные карты E1
• ДСЛАМ
• Мультиплексор Е1
• Системы выборки и хранения
• Жилые шлюзы, Домашний шлюз/маршрутизатор
• Сетевое оборудование Е1
• HDTV