DG411DYZ Overview

As the electronic part is packed in SOIC, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Bulk. In total, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. A 15V voltage supply should turn on and run the electronic component. Internally, this switch multiplexer has a resistance of 80Ohm. To find out what the 16 pins do, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 40V. A analog switch ic that has a cost-effective Dual, Single supply type. The lowest voltage fed to the electronic component should be 5V. 100pA current would be enough for this multiplexer to operate. For this switch, a dual supply voltage is feasible, but it must not exceed 20VIf you are using a dual power supply, you should attach at least 5V. There are SEPARATE OUTPUT outputs on this analog switch ic. Operating voltages range from 28V. Temperatures above 85°C should not be used to operate the switches. There is 25mOhm resistance between Drain and Source for this electronic part. The switch device is capable of conducting in a 4-bit mode.

DG411DYZ Features

1 Channels
100pA Supply Current
Drain-to-Source resistance: 25mOhm
4-Bit

DG411DYZ Applications

There are a lot of Intersil (Renesas Electronics America) DG411DYZ Analog Switches & Multiplexers ICs applications.

Channelized and Unchannelized DS3 applications
PDAs
Optical Applications
Multi-Line E1 Interface Cards
DSLAMs
E1 Multiplexer
Sample-and-hold systems
Residential Gateways, Home Gateway/Router
E1 Network Equipment
HDTV

In Stock : 53